Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2018FUSION PLATINUM HYBRIDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 106 (WIPERS AND WASHERS SYSTEM -- FUSION (EXCEPT HYBRID))
2018 Ford Fusion Platinum Hybrid
Section 106 (Wipers And Washers System -- Fusion (Except Hybrid))
2018 Ford Fusion Platinum HybridSECTION Section 106 (Wipers And Washers System -- Fusion (Except Hybrid))
WARNING: This page is about a different variant/trim than selected.
- Description And Operation
- Diagnosis And Testing
- Wipers and Washers
- DTC Charts
- Symptom Chart: Wiper and Washer
- Pinpoint Tests
- Pinpoint Test A : All Windshield Wiper Modes Are Inoperative From One Or Both Windshield Wiper Motors
- Pinpoint Test B : The Intermittent And/Or Low Speed Windshield Wipers Are Inoperative
- Pinpoint Test C : The High Speed Windshield Wipers Are Inoperative
- Pinpoint Test D : The Windshield Wipers Stay On Continuously
- Pinpoint Test E : The Windshield Wipers Do Not Operate Correctly In The Intermittent Mode
- Pinpoint Test F : The Rain Sensitive Wiper Feature Is Inoperative/Does Not Operate Correctly
- Pinpoint Test G : The Windshield Wipers Do Not Park At The Correct Position
- Pinpoint Test H : The Washer Pump Is Inoperative Or Always On
- Wipers and Washers
- Removal And Installation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.