Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSFORD2018FUSION PLATINUM HYBRIDREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLANTI-LOCK BRAKE SYSTEM (ABS) AND STABILITY CONTROL - FUSION (HYBRID/ENERGI)REMOVAL AND INSTALLATIONANTI-LOCK BRAKE SYSTEM (ABS) MODULEINSTALLATION

2018 Ford Fusion Platinum Hybrid

Anti-Lock Brake System (ABS) Module: Installation

2018 Ford Fusion Platinum HybridSECTION Installation

To install, reverse the removal procedure.
NOTE: This step is only necessary when installing a new component.

Using a diagnostic scan tool, complete the PMI PMI process for the ABS module following the on-screen instructions.
1. Following the diagnostic scan tool instructions, carry out the Master Cylinder Isolation Valve Calibration routine.
2. Following the diagnostic scan tool instructions, carry out the Inlet Valve Calibration routine.
3. Following the diagnostic scan tool instructions, carry out the Regenerative Brake System Calibration routine.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.