Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2018FUSION PLATINUM HYBRIDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS (HYBRID)DIAGNOSTIC TROUBLE CODE (DTC) CHARTS AND DESCRIPTIONSDTC U0300 (SOBDMC) - INTERNAL CONTROL MODULE SOFTWARE INCOMPATIBILITY
2018 Ford Fusion Platinum Hybrid
DTC U0300 (SOBDMC) - Internal Control Module Software Incompatibility
2018 Ford Fusion Platinum HybridSECTION DTC U0300 (SOBDMC) - Internal Control Module Software Incompatibility
U0300 (SOBDMC) - INTERNAL CONTROL MODULE SOFTWARE INCOMPATIBILITY
| Description: | This DTC sets due to an internal software incompatibility issue. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Verify the SOBDMC is at the latest calibration level. Clear the SOBDMC DTCs. Repeat the self-test. If the DTC is retrieved again, install a new TCM. Refer to the appropriate Automatic Transmission article. Refer to FLASH ELECTRICALLY ERASABLE PROGRAMMABLE READ ONLY MEMORY (EEPROM) , Programming the TRID Block for a Replacement TCM. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | Refer to the Description, Possible Causes and Diagnostic Aids for the DTC. | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.