Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2018FUSION PLATINUM HYBRIDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS (HYBRID)DIAGNOSTIC TROUBLE CODE (DTC) CHARTS AND DESCRIPTIONSDTC P0130 - O2 SENSOR CIRCUIT (BANK 1 SENSOR 1)
2018 Ford Fusion Platinum Hybrid
DTC P0130 - O2 Sensor Circuit (Bank 1 Sensor 1)
2018 Ford Fusion Platinum HybridSECTION DTC P0130 - O2 Sensor Circuit (Bank 1 Sensor 1)
P0130 - O2 SENSOR CIRCUIT (BANK 1 SENSOR 1)
| Description: | This DTC sets when a concern is detected with one of the circuits used to determine the oxygen content in the exhaust gas. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Inspect the connectors for signs of damage, water ingress, or corrosion. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST DZ . | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.