SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2018FUSION ENERGI TITANIUMREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS (HYBRID)DIAGNOSTIC TROUBLE CODE (DTC) CHARTS AND DESCRIPTIONSDTC P1A10 - HYBRID POWERTRAIN CONTROL MODULE - BATTERY DISABLED
2018 Ford Fusion Energi Titanium

DTC P1A10 - Hybrid Powertrain Control Module - Battery Disabled

2018 Ford Fusion Energi TitaniumSECTION DTC P1A10 - Hybrid Powertrain Control Module - Battery Disabled
P1A10 - HYBRID POWERTRAIN CONTROL MODULE - BATTERY DISABLED

Description:  This DTC sets when the battery energy control module (BECM) initiated a battery power off (BPO) or no restart event.
Possible Causes: 
  • BECM initiated BPO event
  • BECM initiated no restart event
  • VPWR circuit intermittent open at BECM
  • VPWR circuit intermittent short at BECM
Diagnostic Aids:  This DTC indicates a concern in the high voltage traction battery. Diagnose and repair any BECM DTCs. Refer to the appropriate High Voltage Traction Battery article.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All Refer to the Description, Possible Causes and Diagnostic Aids for the DTC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.