Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2018FUSION ENERGI TITANIUMREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS (HYBRID)DIAGNOSTIC TROUBLE CODE (DTC) CHARTS AND DESCRIPTIONSDTC P1145 - CALCULATED TORQUE ERROR
2018 Ford Fusion Energi Titanium
DTC P1145 - Calculated Torque Error
2018 Ford Fusion Energi TitaniumSECTION DTC P1145 - Calculated Torque Error
P1145 - CALCULATED TORQUE ERROR
| Description: | This DTC sets when the engine is overproducing torque and overcharging the traction battery, when its operating temperature was below the calibrated threshold. To protect the traction battery the powertrain control module (PCM) disabled the fuel injectors. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | This DTC is informational only. Check for any unmetered air leaks. Diagnose any intake air system related DTCs. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | Refer to the Description, Possible Causes and Diagnostic Aids for the DTC. | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.