Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2018FUSION ENERGI TITANIUMREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESMECHANICAL - HYDRAULICANTI-LOCK BRAKE SYSTEM COMPONENT TESTING - FUSION (HYBRID/ENERGI)PINPOINT TESTSPINPOINT TESTS AT: THE ABS MODULE DOES NOT RESPOND TO THE DIAGNOSTIC SCAN TOOLPOSSIBLE CAUSES
2018 Ford Fusion Energi Titanium
Possible Causes
2018 Ford Fusion Energi TitaniumSECTION Possible Causes
- Fuse
- Wiring, terminals or connectors
- ABS module
- AT1: VERIFY THE NO COMMUNICATION DIAGNOSTICS HAVE BEEN PERFORMED NOTE: Diagnostics MUST BE CARRIED OUT before continuing with this pinpoint test. Refer to: Module Communications Network (Hybrid/Energi)
- Has the appropriate pinpoint test been carried out for the no communication concern? Refer to: Module Communications Network (Hybrid/Energi)
Yes No INSTALL a new ABS module.
CHECK OASIS for any applicable service articles: TSB, GSB, SSM or FSA.
If a service article exists for this concern, DISCONTINUE this test and FOLLOW the service article instructions.
If no service articles address this concern, INSTALL a new ABS module. REFER to Anti-Lock Brake System (ABS) And Stability Control (Hybrid/Energi) .
ORDER a replacement ABS module and INCLUDE the RVC on the form.
If this is a Ford paid repair, INCLUDE the RVC on the warranty claim form.
When complete, SELECT the "X" in the top right corner to CLOSE this procedure and RETURN to the PTS web site.REFER to Module Communications Network (Hybrid/Energi) and CARRY OUT the ABS module does not respond to the diagnostic scan tool pinpoint test.
- Has the appropriate pinpoint test been carried out for the no communication concern? Refer to: Module Communications Network (Hybrid/Energi)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.