Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Pinpoint Test Y : DTC: U0212:00: Notes
2018 Ford Fusion Energi TitaniumSECTION Notes
Refer to: Module Communications Network for schematic and connector information.
Normal Operation and Fault Conditions
The DSM and the SCCM communicate using the CAN.
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| U0212:00 | Lost Communication with Steering Column Control Module: No Sub Type Information | Set by the DSM whenever it has lost communication to the BCM for 5 seconds or longer while DSM input voltage is between 10 and 15.5 volts. |
Possible Causes
- Module communication
- DSM
- SCCM
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.