Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2018F-450 SUPER DUTY LARIAT, 4D PICKUP CREW CAB, 4WDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSDTC INDEXDTC INDEX (MODULE COMMUNICATIONS - WIPER & WASHER SYSTEM)WIPER & WASHER SYSTEM DTCSSCCM
2018 Ford F-450 Super Duty Lariat, 4D Pickup Crew Cab, 4WD
Wiper & Washer System DTCS: SCCM
2018 Ford F-450 Super Duty Lariat, 4D Pickup Crew Cab, 4WDSECTION SCCM
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| B1008:09 | Wiper Mode Switch: Component Failure | If the windshield wipers are inoperative, INSTALL a new wiper/washer switch. Refer to: Steering Column Multifunction Switch LH
. CLEAR the DTC and repeat the self-test. If DTC B1008:09 is retrieved again, INSTALL a new SCCM. Refer to: Steering Column Control Module (SCCM) . Refer to: Steering Column Control Module (SCCM) - Vehicles With: Adaptive Steering . If the windshield wipers are on continuously, GO to Pinpoint Test D |
| B1051:09 | Front Washer Switch: Component Failure | INSTALL a new wiper/washer switch. Refer to: Steering Column Multifunction Switch LH
. CLEAR the DTC and repeat the self-test. If DTC B1008:09 is retrieved again, INSTALL a new SCCM. Refer to: Steering Column Control Module (SCCM) . Refer to: Steering Column Control Module (SCCM) - Vehicles With: Adaptive Steering . |
| B10AD:02 | Rain Sensor: General Signal Failure | GO to Pinpoint Test F |
| B10AD:08 | Rain Sensor: Bus Signal / Message Failure | GO to Pinpoint Test F |
| B10AD:49 | Rain Sensor: Internal Electronic Failure | INSTALL a new rain sensor. Refer to: Rain Sensor . |
| B10AD:55 | Rain Sensor: Not Configured | CARRY OUT the PMI for the SCCM using As-Built data. |
| B1131:02 | Wiper motor module: General Signal Failure | If the wipers are inoperative, or no symptom is present, GO to Pinpoint Test A If the wipers are always on, GO to Pinpoint Test D |
| B1131:08 | Wiper motor module: Bus Signal / Message Failure | GO to Pinpoint Test B |
| B1131:11 | Wiper motor module: Circuit Short To Ground | GO to Pinpoint Test B |
| B1131:49 | Wiper motor module: Internal Electronic Failure | INSTALL a new windshield wiper motor. Refer to: Windshield Wiper Motor . |
| B1131:55 | Wiper motor module: Not Configured | CARRY OUT the PMI for the SCCM using As-Built data. |
| B1131:9A | Wiper motor module: Component or System Operating Conditions | DIAGNOSE the symptom present with the wiper/washer system. REFER to Symptom Chart: Wiper and Washer . |
| All other Diagnostic Trouble Codes (DTCs) | - | REFER to: Steering Wheel and Column Electrical Components . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.