Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Reductant Quality Module- Transit
The reductant quality module provides the reductant concentration to the PCM. The reductant quality module incorporates an ultrasonic transducer and sensor assembly, located at the bottom of the reductant tank. The sensor monitors reductant concentration percentage by calculating the speed of sound travel through the diesel exhaust fluid (DEF) and comparing it to an expected value. If this value is not met, the reductant is diluted or contaminated. The reductant quality module is integral to the reductant tank assembly. For addition information on the reductant level sensor, refer to the reductant heater and sender assembly description.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.