Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Conditioning Module (F-150)
| Item | Number | Description |
|---|---|---|
| 1 | - | Water In Fuel (WIF) Sensor |
| 2 | - | Fuel Supply Line To The High Pressure Fuel Injection Pump |
| 3 | - | Fuel Supply Line From The Fuel Tank |
| 4 | - | Fuel Drain Valve |
Fuel Conditioning Module - F-650/F-750
The internal components of the fuel conditioning module include the following:
- electric fuel pump
- 10 micron fuel filter and water separator
- water in fuel (WIF) sensor
- recirculation thermostat
The electric fuel pump draws fuel from the fuel tank through the fuel supply line. When the fuel enters the fuel conditioning module, water is separated from the fuel before it flows through the 10 micron fuel filter which separates particles from the fuel. The separated water collects at the bottom of the pump. If enough water is collected, the WIF sensor detects it and the PCM illuminates the WIF indicator. The conditioned fuel is then delivered to the secondary fuel filter.
The vented fuel from the fuel pressure control valve returns from the secondary fuel filter through the fuel return port and enters the unfiltered side of the fuel conditioning module. Depending on the fuel temperature returning from the secondary fuel filter, the recirculation thermostat directs the fuel to the fuel tank or through the fuel conditioning module back to the inlet of the primary filter.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.