Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Pinpoint Test M : U0104:00: Notes
Refer to Module Communications Network for schematic and connector information.
Normal Operation and Fault Conditions
With the ignition ON, the CCM sends messages to the ABS module over the HS-CAN2. If the ABS module does not receive these messages within the specified time frame, the module sets a DTC. This can be due to a CCM failure, a circuit failure on the network or an excessive load on the network. For information on the messages sent to the ABS module by the CCM, REFER to: Anti-Lock Brake System (ABS) and Stability Control - System Operation and Component Description .
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| U0104:00 | Lost Communication With Cruise Control Module: No Sub Type Information | This DTC sets in continuous memory in the ABS module if the ABS module does not receive any messages from the CCM. |
Possible Causes
- Wiring, terminals or connectors
- Network communication concern
- CCM
- ABS module
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.