Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2018F-150 XLT, 4D PICKUP EXTRA CAB, 3.5L ENG VIN G, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSDTC INDEXDTC INDEX - (ANTI LOCK BRAKE SYSTEM - ELECTRONIC ENGINE CONTROLS)ANTI-THEFT SYSTEM DTCSPASSIVE WITHOUT KEYLESS VEHICLE SYSTEMBCM
2018 Ford F-150 XLT, 4D Pickup Extra Cab, 3.5L Eng VIN G, RWD
Passive Without Keyless Vehicle System: BCM
2018 Ford F-150 XLT, 4D Pickup Extra Cab, 3.5L Eng VIN G, RWDSECTION BCM
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| B10D5:13 | PATS Antenna: Circuit Open | INSTALL a new PATS transceiver. REFER to: Passive Anti-Theft System (PATS) Transceiver . |
| B10D7:05 | PATS Key: System Programming Failure | GO to Pinpoint Test B |
| B10D7:51 | PATS Key: Not Programmed | PROGRAM the PATS key in question. REFER to: Anti-Theft Key Programming - Scan Tool . |
| B10D7:55 | PATS Key: Not Configured | The CEI Lock Configuration within the BODY>SERVICE FUNCTIONS tab was not completed during the PMI procedure. CARRY OUT the CEI Lock Configuration as part of the PMI procedure. |
| B10D7:87 | PATS Key: Missing Message | GO to Pinpoint Test D |
| B10D7:8F | PATS Key: Erratic | GO to Pinpoint Test C |
| B10D8:00 | PATS Key Less Than Minimum Programmed: No Sub Type Information | Less than 2 keys are programmed (minimum of 2 keys must be programmed). CYCLE the customer's second key in the ignition key cylinder to program (when less than 2 keys are programmed, the BCM automatically programs the first 2 keys that are cycled in the ignition key cylinder). |
| B10D9:87 | PATS Transponder: Missing Message | GO to Pinpoint Test E |
| B10DA:51 | PATS Target Identifier: Not Programmed | There is no PCM ID stored in the BCM memory. CARRY OUT the parameter reset procedure. REFER to: Anti-Theft Key Programming - Scan Tool . |
| C113A:11 | Wakeup Control: Circuit Short To Ground | GO to Pinpoint Test F |
| C113A:15 | Wakeup Control: Circuit Short To Battery or Open | GO to Pinpoint Test F |
| All other Diagnostic Trouble Codes (DTCs) | - | REFER to: Body Control Module (BCM) . . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.