SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2018F-150 XLT, 4D PICKUP EXTRA CAB, 3.5L ENG VIN G, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESBRAKES CONTROL SYSTEMSABS GUIDED ROUTINE TESTINGPINPOINT TESTSPINPOINT TESTS E: THE TRACTION CONTROL SYSTEM IS INOPERATIVE OR CANNOT BE DISABLED USING THE MESSAGE CENTERNORMAL OPERATION AND FAULT CONDITIONS
2018 Ford F-150 XLT, 4D Pickup Extra Cab, 3.5L Eng VIN G, RWD

Normal Operation and Fault Conditions

2018 Ford F-150 XLT, 4D Pickup Extra Cab, 3.5L Eng VIN G, RWDSECTION Normal Operation and Fault Conditions

The stability-traction control disabled indicator (sliding car OFF icon) in the IPC provides traction control system status to the driver. When the driver deactivates the traction control, the IPC sends a message to the GWM over the HS-CAN 3 indicating the driver has requested the traction control to be disabled. The GWM relays this message to the ABS module over the HS-CAN 2. The ABS module continues to monitor for excessive wheel spin, but no longer takes any action when a traction event is detected. 

After receiving the traction control status message from the IPC, the ABS module then sends a message to the GWM over the HS-CAN 2 to illuminate the stability-traction control disabled indicator (sliding car OFF icon). The GWM relays this message to the IPC over the HS-CAN 3. The IPC responds by illuminating the stability-traction control disabled indicator (sliding car OFF icon). The traction control system remains deactivated until the driver changes the traction control state in the message center or until the ignition is cycled. 

NOTE: If equipped, MyKey allows users to configure traction control to be either always on or selectable. If a MyKey restricted key is in use with the MyKey traction control feature configured to always on, traction control cannot be disabled. An admin key must be used to enable and disable traction control.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.