Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2018EXPEDITION MAX LIMITED, 4WDREPAIR AND DIAGNOSISBRAKESBRAKES CONTROL SYSTEMSABS GUIDED ROUTINE TESTINGPINPOINT TESTSPINPOINT TESTS Z: ABS MODULE CONFIGURATION CONCERNNORMAL OPERATION AND FAULT CONDITIONS
2018 Ford Expedition MAX Limited, 4WD
Normal Operation and Fault Conditions
2018 Ford Expedition MAX Limited, 4WDSECTION Normal Operation and Fault Conditions
During new module installation, configuration files are loaded into the new module being replaced. If a discrepancy is detected between the modules or an incomplete programming procedure is carried out, a DTC sets.
PPT Z ABS MODULE DTC FAULT TRIGGER CONDITIONS
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| U0300:51 | Internal Control Module Software Incompatibility: Not Programmed | This DTC sets when the software release level has not been programmed into the module. This is most likely due to incomplete or improper module programming procedures. |
| U2016:47 | Control Module Main Software: Watchdog/Safety Micro-Controller Failure | Sets due to incomplete or improper module programming procedures. |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | Sets due to incomplete or improper module programming procedures. |
| U2101:00 | Control Module Configuration Incompatible: No Sub Type Information | Sets due to incomplete or improper module programming procedures. |
| U2200:00 | Control Module Configuration Memory Corrupt: No Sub Type Information | Sets due to incomplete or improper module programming procedures. |
PPT Z SASM DTC FAULT TRIGGER CONDITIONS
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| U2016:47 | Control Module Main Software: Watchdog/Safety Micro-Controller Failure | Sets due to incomplete or improper module programming procedures. |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | Sets due to incomplete or improper module programming procedures. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.