Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2018EXPEDITION MAX LIMITED, 4WDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSWIRING DIAGRAMSOEM CONNECTOR END VIEWS C3385 - C9804CONNECTOR VIEWSCONNECTOR END VIEW (C3433) - SHIFT INTERLOCK OVERRIDE SWITCH
2018 Ford Expedition MAX Limited, 4WD
Connector End View (C3433) - SHIFT INTERLOCK OVERRIDE SWITCH
2018 Ford Expedition MAX Limited, 4WDSECTION Connector End View (C3433) - SHIFT INTERLOCK OVERRIDE SWITCH
| Connector: | Description | Color | Harness | Base Part # | Service Pigtail | |
|---|---|---|---|---|---|---|
| C3433 | SHIFT INTERLOCK OVERRIDE SWITCH | 14B079/14K042 | part# N/A | See Below | ||
| Terminal Part Number | Service Part Number | Size |
|---|---|---|
| 8U5T-14474-BB | DU2Z-14474-CA | 0.64 |
| Pin | Circuit | Gauge | Circuit Function | Qualifier | Terminal Part Number | |||
|---|---|---|---|---|---|---|---|---|
| 1 | * | * | Not Used | N/A | ||||
| 2 | GD214 (BK-BU) | 22 | GROUND - INSTRUMENT PANEL STRUCTURE | 8U5T-14474-BB | ||||
| 3 | * | * | Not Used | N/A | ||||
| 4 | CET82 (GN-VT) | 22 | SWITCH - SHIFT-BY-WIRE OVERRIDE 1 (OVERRIDE_SW_1) | 8U5T-14474-BB | ||||
| 5 | * | * | Not Used | N/A | ||||
| 6 | CET83 (BU-OG) | 22 | SWITCH - SHIFT-BY-WIRE OVERRIDE 2 (OVERRIDE_SW_2) | 8U5T-14474-BB | ||||
Available Pigtail Kits
Pigtail Kit Part Number WPT-1518
Service Part Number:
JU2Z-14S411-NA
Gauge:
20
Pin material:
Silver
Cavities:
6
Vehicle Uses:
- Switch - Deck Lid / Hatch Release
- Switch - Lift Gate Shutface
- Switch - Power Liftgate
- Switch - Shift By Wire Override
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.