Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2018EDGE SEL, 2.0L ENG VIN 9, AWDREPAIR AND DIAGNOSISQUICK LOOKUPSDTC INDEXDTC INDEX (ANTI-LOCK BRAKE SYSTEM AND STABILITY CONTROL - EXTERIOR LIGHTING SYSTEM)COLLISION WARNING SYSTEM AND COLLISION AVOIDANCE SYSTEM DTCSHUD
2018 Ford Edge SEL, 2.0L Eng VIN 9, AWD
Collision Warning System And Collision Avoidance System DTCS: HUD
2018 Ford Edge SEL, 2.0L Eng VIN 9, AWDSECTION HUD
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| U0104:00 | Lost Communication With Cruise Control Module: No Sub Type Information | GO to Pinpoint Test C |
| U0146:00 | Lost Communication With Gateway "A": No Sub Type Information | GO to Pinpoint Test D |
| U0405:68 | Invalid Data Received From Cruise Control Module: Event Information | RETRIEVE and FOLLOW non-network Diagnostic Trouble Codes (DTCs) from the CCM. REFER to: Cruise Control . If no Diagnostic Trouble Codes (DTCs) are present in the CCM, DIAGNOSE the observable symptom. |
| U0447:68 | Invalid Data Received From Gateway "A": Event Information | RETRIEVE and FOLLOW non-network Diagnostic Trouble Codes (DTCs) from the GWM. REFER to: Communications Network . If no Diagnostic Trouble Codes (DTCs) are present in the GWM, DIAGNOSE the observable symptom. |
| U210A:16 | Temperature Sensor: Circuit Voltage Below Threshold | GO to Pinpoint Test F |
| U210A:17 | Temperature Sensor: Circuit Voltage Above Threshold | GO to Pinpoint Test F |
| U3000:41 | Control Module: General Checksum Failure | CLEAR the Diagnostic Trouble Codes (DTCs). REPEAT the self-test. If DTC U3000:41 is retrieved again, INSTALL a new HUD module. REFER to: Head Up Display (HUD) Module . |
| U3003:16 | Battery Voltage: Circuit Voltage Below Threshold | GO to Pinpoint Test G |
| U3003:1C | Battery Voltage: Circuit Voltage Out of Range | GO to Pinpoint Test H |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.