Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2014TAURUS LIMITED, 2.0L ENG VIN 9REPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSWIRING DIAGRAMSOEM CONNECTOR END VIEWSGENERIC FUNCTION MODULE (GFM) CONNECTOR END VIEW (C2464)
2014 Ford Taurus Limited, 2.0L Eng VIN 9
Generic Function Module (GFM) Connector End View (C2464)
2014 Ford Taurus Limited, 2.0L Eng VIN 9SECTION Generic Function Module (GFM) Connector End View (C2464)
| Pin | Circuit | Gauge | Circuit Function | Qualifier |
|---|---|---|---|---|
| 1 | CBP42 (GN) | 22 | FUSE - 42 OR CIRCUIT BREAKER | |
| 2 | * | * | Not Used | |
| 3 | CAP14 (GY-BN) | 22 | POLICE - BUTTON FUNCTION 1 | |
| 4 | CAP18 (GN-OG) | 22 | POLICE - SWITCH 4-FUNCTION CONTROL AUX1 | |
| 5 | CAP15 (WH-VT) | 22 | POLICE - BUTTON FUNCTION 2 | |
| 6 | VDB04 (WH-BU) | 22 | CONNECTOR - DIAGNOSTIC # CAN BUS HIGH SPEED HIGH | |
| 7 | RAP18 (BN-BU) | 22 | POLICE - SWITCH 4-FUNCTION CONTROL | |
| 8 | * | * | Not Used | |
| 9 | CAP16 (GN-BN) | 22 | POLICE - BUTTON FUNCTION 3 | |
| 10 | CAP19 (GY-VT) | 22 | POLICE - SWITCH 4-FUNCTION CONTROL AUX2 | |
| 11 | CAP17 (YE-GY) | 22 | POLICE - BUTTON FUNCTION 4 | |
| 12 | * | * | Not Used | |
| 13 | VDB05 (WH) | 22 | CONNECTOR - DIAGNOSTIC # CAN BUS HIGH SPEED LOW | |
| 14 | GD374 (BK-WH) | 20 | GROUND - TUNNEL (BC3T) |
| Available Pigtail Kits | |
|---|---|
| Pigtail Kit Part Number WPT-741 | Service Part Number: 3U2Z-14S411-BJAA Gauge: 12 16 Pin material: Tin Cavities: 14 Vehicle Uses
|
| Pigtail Kit Part Number WPT-955 | Service Part Number: 3U2Z-14S411-BJAC Gauge: 12 14 16 Pin material: Tin & Silver Cavities: 14 Vehicle Uses
|
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.