Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2014TAURUS LIMITED, 2.0L ENG VIN 9REPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSDTC INDEXSEAT SYSTEM DTCSHVAC MODULE
2014 Ford Taurus Limited, 2.0L Eng VIN 9
HVAC Module
2014 Ford Taurus Limited, 2.0L Eng VIN 9SECTION HVAC Module
DTC INDEX
| DTC | Description | Action to Take |
|---|---|---|
| B1034:11 | Left Front Seat Heater Element: Circuit Short to Ground | GO to PINPOINT TEST V . |
| B1034:13 | Left Front Seat Heater Element: Circuit Open | GO to PINPOINT TEST V . |
| B1036:11 | Right Front Seat Heater Element: Circuit Short to Ground | GO to PINPOINT TEST W . |
| B1036:13 | Right Front Seat Heater Element: Circuit Open | GO to PINPOINT TEST W . |
| B1038:11 | Left Front Seat Heater Sensor: Circuit Short to Ground | GO to PINPOINT TEST V . |
| B1038:12 | Left Front Seat Heater Sensor: Circuit Short to Battery | GO to PINPOINT TEST V . |
| B103A:11 | Right Front Seat Heater Sensor: Circuit Short to Ground | GO to PINPOINT TEST W . |
| B103A:12 | Right Front Seat Heater Sensor: Circuit Short to Battery | GO to PINPOINT TEST W . |
| All Other DTCs | - | REFER to the HVAC module DTC Chart(s) in CLIMATE CONTROL SYSTEM - GENERAL INFORMATION AND DIAGNOSTICS . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.