Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2014TAURUS LIMITED, 2.0L ENG VIN 9REPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSDTC INDEXINTERIOR LIGHTING SYSTEM DTCSBODY CONTROL MODULE (BCM)
2014 Ford Taurus Limited, 2.0L Eng VIN 9
Body Control Module (BCM)
2014 Ford Taurus Limited, 2.0L Eng VIN 9SECTION Body Control Module (BCM)
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| B1175:01 | Driver Door Ajar Switch: General Electrical Failure | GO to PINPOINT TEST F . |
| B1176:01 | Passenger Door Ajar Switch: General Electrical Failure | GO to PINPOINT TEST F . |
| B11C0:01 | Driver Side Rear Door Ajar Switch: General Electrical Failure | GO to PINPOINT TEST F . |
| B11C1:01 | Passenger Side Rear Door Ajar Switch: General Electrical Failure | GO to PINPOINT TEST F . |
| B12C2:11 | Puddle Lamp: Circuit Short To Ground | GO to PINPOINT TEST D . |
| B12C2:15 | Puddle Lamp: Circuit Short To Battery or Open | GO to PINPOINT TEST G . |
| B1313:11 | Interior Lighting Output: Circuit Short To Ground | GO to PINPOINT TEST C . |
| B1313:15 | Interior Lighting Output: Circuit Short To Battery or Open | If the interior courtesy lamps are inoperative, GO to PINPOINT TEST C
. If the interior courtesy lamps are always on, GO to PINPOINT TEST H . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.