Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2014TAURUS LIMITED, 2.0L ENG VIN 9REPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS - PINPOINT TEST A: NO START THROUGH PINPOINT TEST DN: PRESSURE AND TEMPERATURE SENSORS - (EXCEPT DIESEL & HYBRID)
2014 Ford Taurus Limited, 2.0L Eng VIN 9
Engine Controls - Pinpoint Test A: No Start Through Pinpoint Test DN: Pressure And Temperature Sensors - (Except Diesel & Hybrid)
2014 Ford Taurus Limited, 2.0L Eng VIN 9SECTION Engine Controls - Pinpoint Test A: No Start Through Pinpoint Test DN: Pressure And Temperature Sensors - (Except Diesel & Hybrid)
- PINPOINT TEST A: No Start
- PINPOINT TEST AA: Auto Stop Start
- PINPOINT TEST B: Powertrain Control Module (PCM) Power Relay
- PINPOINT TEST C: Reference Voltage (VREF)
- PINPOINT TEST DA: Intake Air Temperature (IAT) Sensor
- PINPOINT TEST DC: Mass Airflow (MAF) Sensor
- PINPOINT TEST DD: Fuel Pressure, Fuel Rail Pressure (FRP) and Fuel Rail Pressure Temperature (FRPT) Sensors
- PINPOINT TEST DF: Vehicle Speed Circuit (VSC) Check
- PINPOINT TEST DG: Knock Sensor (KS)
- PINPOINT TEST DI: Direct Fuel Injection Fuel Injector
- PINPOINT TEST DK: Accelerator Pedal Position (APP) Sensor
- PINPOINT TEST DL: Cylinder Head Temperature (CHT) Sensor
- PINPOINT TEST DM: Manifold Absolute Pressure (MAP) Sensor
- PINPOINT TEST DN: Pressure and Temperature Sensors
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.