Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2014TAURUS LIMITED, 2.0L ENG VIN 9REPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALSTARTERSTARTING SYSTEMDIAGNOSIS AND TESTINGSTARTING SYSTEMPINPOINT TESTSPINPOINT TEST A: THE ENGINE DOES NOT CRANK (WITHOUT PUSH BUTTON START)VISUAL INSPECTION AND DIAGNOSTIC PRE-CHECKS
2014 Ford Taurus Limited, 2.0L Eng VIN 9
Visual Inspection and Diagnostic Pre-checks
2014 Ford Taurus Limited, 2.0L Eng VIN 9SECTION Visual Inspection and Diagnostic Pre-checks
- Inspect the Run/start relay.
- Inspect the Starter relay.
- Verify the BJB fuse 19 (30A).
- Verify the BCM fuse 18 (10A).
- Verify the BCM fuse 26 (5A).
- Inspect the IKT.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.