Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2014TAURUS LIMITED, 2.0L ENG VIN 9REPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALBODY ELECTRICALOEM CONNECTOR END VIEWSGENERIC FUNCTION MODULE (GFM) CONNECTOR END VIEW (C2464)
2014 Ford Taurus Limited, 2.0L Eng VIN 9
Generic Function Module (GFM) Connector End View (C2464)
2014 Ford Taurus Limited, 2.0L Eng VIN 9SECTION Generic Function Module (GFM) Connector End View (C2464)
| Pin | Circuit | Gauge | Circuit Function | Qualifier |
|---|---|---|---|---|
| 1 | CBP42 (GN) | 22 | FUSE - 42 OR CIRCUIT BREAKER | |
| 2 | * | * | Not Used | |
| 3 | CAP14 (GY-BN) | 22 | POLICE - BUTTON FUNCTION 1 | |
| 4 | CAP18 (GN-OG) | 22 | POLICE - SWITCH 4-FUNCTION CONTROL AUX1 | |
| 5 | CAP15 (WH-VT) | 22 | POLICE - BUTTON FUNCTION 2 | |
| 6 | VDB04 (WH-BU) | 22 | CONNECTOR - DIAGNOSTIC # CAN BUS HIGH SPEED HIGH | |
| 7 | RAP18 (BN-BU) | 22 | POLICE - SWITCH 4-FUNCTION CONTROL | |
| 8 | * | * | Not Used | |
| 9 | CAP16 (GN-BN) | 22 | POLICE - BUTTON FUNCTION 3 | |
| 10 | CAP19 (GY-VT) | 22 | POLICE - SWITCH 4-FUNCTION CONTROL AUX2 | |
| 11 | CAP17 (YE-GY) | 22 | POLICE - BUTTON FUNCTION 4 | |
| 12 | * | * | Not Used | |
| 13 | VDB05 (WH) | 22 | CONNECTOR - DIAGNOSTIC # CAN BUS HIGH SPEED LOW | |
| 14 | GD374 (BK-WH) | 20 | GROUND - TUNNEL (BC3T) |
| Available Pigtail Kits | |
|---|---|
| Pigtail Kit Part Number WPT-741 | Service Part Number: 3U2Z-14S411-BJAA Gauge: 12 16 Pin material: Tin Cavities: 14 Vehicle Uses
|
| Pigtail Kit Part Number WPT-955 | Service Part Number: 3U2Z-14S411-BJAC Gauge: 12 14 16 Pin material: Tin & Silver Cavities: 14 Vehicle Uses
|
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.