Accessory Protocol Interface Module (APIM) Programming - Module Replacement

2014 Ford Taurus Limited, 2.0L Eng VIN 9SECTION Accessory Protocol Interface Module (APIM) Programming - Module Replacement
SPECIAL TOOL DESCRIPTION

G06136947
Vehicle Communication Module (VCM) and Integrated Diagnostic System (IDS) software with appropriate hardware, or equivalent scan tool
G09734108
SYNC® Re-Flash Kit CCMSYNC-KIT or equivalent
(Tools are also available individually CCMUSB2-AM-AM-10 [cable] and CCMUSB-AF-BF5 [adapter])
NOTE: Use this procedure to program and provision the module when a new Accessory Protocol Interface Module (APIM) is being installed. For additional information on choosing the correct programming procedure, refer to Information and Entertainment System  , APIM PROGRAMMING .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.