Speaker, Left Door Connector End View (C523)

2014 Ford Mustang GT, 2D Coupe, Automatic TransSECTION Speaker, Left Door Connector End View (C523)
Fig 1: Identifying Speaker, Left Door Connector (C523)
G09283597Courtesy of FORD MOTOR CO.
Pin Circuit Gauge Circuit Function Qualifier
1 VME07 (WH) 18 CTRL MOD. - AUDIO # SPEAKER LEFT FRONT DOOR (WOOFER)  
2 RME07 (WH-BN) 18 CTRL MOD. - AUDIO # SPEAKER LEFT FRONT DOOR (WOOFER)  
Available Pigtail Kits  
Pigtail Kit Part Number WPT-984 
G09283598
Service Part Number: 3U2Z-14S411-BXAB 
Gauge: 16 
Pin material: Silver 
Cavities:
Vehicle Uses
  • A/C Compressor Clutch
  • EGR Cooler Outlet
  • Electronic Locking Differential
  • Horn
  • Lamp - CHMSL (Center High Mount Stop Lamp)
  • Lamp - Rear Park
  • Lamp - Reverse
  • Lamp - Side Marker
  • Motor - Adjustable Pedal
  • Sensor - Adjustable Pedal
  • Sensor - Brake Fluid Level
  • Sensor - Cam Shaft Position
  • Sensor - Cylinder Head Temperature
  • Sensor - Exhaust Gas Temperature
  • Sensor - Liftgate Obstacle
  • Sensor - Oil Level
  • Sensor - Output Shaft Speed
  • Sensor - Speed
  • Solenoid - Engine Variable Timing
  • Speaker - Door
  • Speaker - Front
  • Speaker - Rear
  • Speaker - Subwoofer
  • Speaker - Tweeter - LH - Front
  • Switch - A/C Compressor Clutch Cycling
  • Switch - Backup Lamp
  • Switch - Deck Lid/Hatch Release
  • Switch - Deck Lid/Lift Gate Ajar
  • Switch - Hood Ajar
  • Switch - Lift Gate Glass Ajar
  • Switch - Power Liftgate
  • Switch - Reverse Park Aid
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.