SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2014MUSTANG GT, 2D COUPE, AUTOMATIC TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS (EXCEPT DIESEL & HYBRID)DTC DIAGNOSISP0602 - POWERTRAIN CONTROL MODULE PROGRAMMING ERROR
2014 Ford Mustang GT, 2D Coupe, Automatic Trans

P0602 - Powertrain Control Module Programming Error

2014 Ford Mustang GT, 2D Coupe, Automatic TransSECTION P0602 - Powertrain Control Module Programming Error
P0602 - POWERTRAIN CONTROL MODULE PROGRAMMING ERROR

Description:  This DTC sets when there is a programming error within the vehicle identification (VID) block.
Possible Causes: 
  • VID data corrupted by the scan tool during VID reprogramming
Diagnostic Aids:  Program the VID block. Refer to FLASH ELECTRICALLY ERASABLE PROGRAMMABLE READ ONLY MEMORY (EEPROM) , Making Changes to the VID Block. If the PCM does not allow reprogramming of the VID block, reflashing of the PCM is required.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All Refer to the Description, Possible Causes and Diagnostic Aids for the DTC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.