Audio Input Jack Connector End View (C2362)

2014 Ford Mustang GT, 2D Coupe, Automatic TransSECTION Audio Input Jack Connector End View (C2362)
Fig 1: Identifying Audio Input Jack Connector (C2362)
G09283876Courtesy of FORD MOTOR CO.
Pin Circuit Gauge Circuit Function Qualifier
1 VME46 (GN) 26 JACK - AUDIO # EXT. AUX IN RIGHT (+)  
2 RME46 (WH) 26 JACK - AUDIO # EXT. AUX IN RIGHT (-)  
3 RME45 (YE) 26 JACK - AUDIO # EXT. AUX IN LEFT (-)  
4 VME45 (BU) 26 JACK - AUDIO # EXT. AUX IN LEFT (+)  
Available Pigtail Kits  
Pigtail Kit Part Number WPT-465 
G09283877
Service Part Number: 3U2Z-14S411-PRA 
Gauge: 18 
Pin material: Tin 
Cavities:
Vehicle Uses
  • Lamp - CHMSL (Center High Mount Stop Lamp)
  • Module - Anti-theft
  • Module - Power Moonroof
  • Switch - 4x4 Control
  • Switch - Clutch Pedal Position
  • Switch - Deck Lid/Lift Gate Ajar
  • Switch - Door Lock (LH)
  • Switch - Lift Gate Glass Ajar
  • Switch - Message Center
  • Switch - Moon Roof/Sun Roof
  • Transceiver - Passive Anti-Theft (PATS)
Pigtail Kit Part Number WPT-1139 
G09283878
Service Part Number: 3U2Z-14S411-PRC 
Gauge: 18 
Pin material: Silver 
Cavities:
Vehicle Uses
  • Connector - Audio Input
  • Lamp - CHMSL (Center High Mount Stop Lamp)
  • Module - Anti-theft
  • Module - Power Moonroof
  • Sensor - Steering Wheel Position
  • Switch - 4x4 Control
  • Switch - Clutch Pedal Position
  • Switch - Deck Lid/Lift Gate Ajar
  • Switch - Door Lock (LH)
  • Switch - Door Lock (RH)
  • Switch - Lift Gate Glass Ajar
  • Switch - Message Center
  • Switch - Moon Roof/Sun Roof
  • Transceiver - Passive Anti-Theft (PATS)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.