SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2014FOCUS TITANIUM, 4D HATCHBACK, AUTOMATIC DCT TRANS, GAS/ETHANOLREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS - PINPOINT TEST JE: INTEGRATED IGNITION COIL PACK THROUGH PINPOINT TEST Z: INTERMITTENT - (EXCEPT DIESEL & HYBRID)PINPOINT TEST QC: ON BOARD DIAGNOSTIC (OBD) SYSTEMS READINESSTEST PROCEDURE
2014 Ford Focus Titanium, 4D Hatchback, Automatic DCT Trans, Gas/Ethanol

Test Procedure

2014 Ford Focus Titanium, 4D Hatchback, Automatic DCT Trans, Gas/EthanolSECTION Test Procedure
  1. QC1 CHECK FOR PTO 

    Is the vehicle equipped with PTO? 

    Yes No
    GO to QC2  . INFORM the customer the law in your area may require additional driving to complete an inspection/maintenance test.
  2. QC2 CHECK THE PTO PID 
    • Ignition ON, engine running.
    • Access the PCM and monitor the PTO (MODE) PID.
    • Cycle the PTO switch/actuator ON and OFF. (Follow the PTO aftermarket instructions).

    Does the PTO PID cycle ON and OFF? 

    Yes No
    INFORM the customer the law in your area may require additional driving to complete an inspection/maintenance test. GO to PINPOINT TEST FB .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.