Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2014FOCUS TITANIUM, 4D HATCHBACK, AUTOMATIC DCT TRANS, GAS/ETHANOLREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALWIRING DIAGRAMSOEM CONNECTOR END VIEWS - EXCEPT ELECTRIC - C819 - C2057ROOF OPENING PANEL MODULE CONNECTOR END VIEW (C921)
2014 Ford Focus Titanium, 4D Hatchback, Automatic DCT Trans, Gas/Ethanol
Roof Opening Panel Module Connector End View (C921)
2014 Ford Focus Titanium, 4D Hatchback, Automatic DCT Trans, Gas/EthanolSECTION Roof Opening Panel Module Connector End View (C921)
| Pin | Circuit | Gauge | Circuit Function | Qualifier |
|---|---|---|---|---|
| 1 | GD138 (BK-WH) | 14 | GROUND - PILLAR A RIGHT | |
| 2 | * | * | Not Used | |
| 3 | CPR22 (WH-BN) | 22 | RELAY - MOON/SUN ROOF | |
| 4 | * | * | Not Used | |
| 5 | CPR40 (YE-OG) | 22 | SWITCH - MOON/SUN ROOF OPEN | |
| 6 | CBP80 (OG-BK) | 14 | FUSE OUTPUT OR CIRCUIT BREAKER | |
| 7 | * | * | Not Used | |
| 8 | * | * | Not Used | |
| 9 | * | * | Not Used | |
| 10 | CPR31 (VT-BN) | 22 | SWITCH - MOON/SUN ROOF CLOSE |
| Available Pigtail Kits | |
|---|---|
| Pigtail Kit Part Number WPT-1037 | Service Part Number: 1U2Z-14S411-BLB Gauge: 14 Pin material: Silver Cavities: 10 Vehicle Uses
|
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.