Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2014FOCUS ELECTRICREPAIR AND DIAGNOSISQUICK LOOKUPSDTC INDEX (ELECTRIC)WHEELS & TIRES DTCS
2014 Ford Focus Electric
Wheels & Tires DTCS
2014 Ford Focus ElectricSECTION Wheels & Tires DTCS
BCM DTC CHART
| DTC | Description | Action |
|---|---|---|
| B1182:00 | Tire Pressure Monitoring System: No Sub Type Information | GO to PINPOINT TEST A |
| B1182:55 | Tire Pressure Monitoring System: Not Configured | This DTC
is only present when a new BCM
is installed, or the BCM
is flashed or reconfigured. Using a scan tool, CONFIGURE the BCM
, REFER to: MODULE CONFIGURATION - SYSTEM OPERATION AND COMPONENT DESCRIPTION . TRAIN the TPMS sensors, REFER to: TIRE PRESSURE MONITORING SYSTEM (TPMS) SENSOR LOCATION CALIBRATION . CARRY OUT a BCM self-test to clear the DTC . |
| B124D:02 | Tire Pressure Sensor: General Signal Failure |
|
| B1251:00 | Tire Pressure Sensor Low Battery: No Sub Type Information | GO to PINPOINT TEST C |
| B1254:51 | Right Rear (Outside on Dual Wheel) Tire Pressure Sensor and Transmitter Assembly: Not Programmed | This DTC
is only present when a new BCM
is installed, or the BCM
is flashed or reconfigured. REFER to: TIRE PRESSURE MONITORING SYSTEM (TPMS) SENSOR LOCATION CALIBRATION . |
| B1255:51 | Left Rear (Outside On Dual Wheel) Tire Pressure Sensor and Transmitter Assembly: Not Programmed | This DTC
is only present when a new BCM
is installed, or the BCM
is flashed or reconfigured. REFER to: TIRE PRESSURE MONITORING SYSTEM (TPMS) SENSOR LOCATION CALIBRATION . |
| C1A56:51 | Left Front Tire Pressure Sensor and Transmitter Assembly: Not Programmed | This DTC
is only present when a new BCM
is installed, or the BCM
is flashed or reconfigured. REFER to: TIRE PRESSURE MONITORING SYSTEM (TPMS) SENSOR LOCATION CALIBRATION . |
| C1A58:51 | Right Front Tire Pressure Sensor and Transmitter Assembly: Not Programmed | This DTC
is only present when a new BCM
is installed, or the BCM
is flashed or reconfigured. REFER to: TIRE PRESSURE MONITORING SYSTEM (TPMS) SENSOR LOCATION CALIBRATION . |
| - | All Other BCM Diagnostic Trouble Codes (DTCs) | REFER to: BODY CONTROL MODULE (BCM) . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.