Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Post Crash Alert Function
The post crash alert is a function controlled by the BCM. If the Restraints Control Module (RCM) determines an impact of enough severity (the air bags may or may not be deployed), the RCM sends a message to the BCM over the High Speed Controller Area Network (HS-CAN) and the post crash alert function is activated. The post-crash alert function activates the hazard lamp function and cycles the horn on 3 times, then off for 4 seconds, and repeats this cycle until the battery is discharged or the function is turned off. The post crash alert function can be turned off by:
- pressing the hazard flasher lamp switch (which may need to be pressed more than once).
- pressing the RKE transmitter UNLOCK button.
- pressing the RKE transmitter PANIC button.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.