Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2014F-150 FX2, 2D PICKUPREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 738 (SIDE AND REAR VISION SYSTEM)
2014 Ford F-150 FX2, 2D Pickup
Section 738 (Side And Rear Vision System)
2014 Ford F-150 FX2, 2D PickupSECTION Section 738 (Side And Rear Vision System)
WARNING: This page is about a different car, the 2015 Lincoln MKS. However, it is still accessible from the selected car via links, so may be relevant.
- Description And Operation
- Diagnosis And Testing
- Blind Spot Monitoring
- Notes
- DTC Charts
- Symptom Chart
- Pinpoint Tests
- Pinpoint Test A : BLIS® Is Inoperative Or Does Not Operate Correctly
- Pinpoint Test B : The CTA System Is Inoperative Or Does Not Operate Correctly
- Pinpoint Test C : An Exterior Mirror Led Is Constantly On And An IPC Message Is Present
- Pinpoint Test D : DTC B11D6:11 Or DTC B11D6:15
- Pinpoint Test E : The Sod-R Does Not Respond To The Scan Tool Or Cannot Be Configured
- Pinpoint Test F : The IPC Message Center Displays A Blocked Sensor Message
- Pinpoint Test G : The BLIS® And CTA System Cannot Be Turned Off In The IPC Message Center
- Pinpoint Test H : DTC U3000:44, 45, 46, 48, 49 Or 4A
- Pinpoint Test I : An Exterior Mirror BLIS® /CTA Led Is Constantly On
- Pinpoint Test J : DTC U0140:00
- Blind Spot Monitoring
- Removal And Installation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.