Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2014F-150 FX2, 2D PICKUPREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 698 (CRUISE CONTROL SYSTEM - NON-ADAPTIVE)DIAGNOSIS AND TESTINGCRUISE CONTROLSYMPTOM CHART
2014 Ford F-150 FX2, 2D Pickup
Symptom Chart
2014 Ford F-150 FX2, 2D PickupSECTION Symptom Chart
WARNING: This page is about a different car, the 2015 Lincoln MKS. However, it is still accessible from the selected car via links, so may be relevant.
Diagnostics in this service information assume a certain skill level and knowledge of Ford-specific diagnostic practices. Refer to Diagnostic Methods in Service Information for information about these practices.
Symptom Chart
| Condition | Possible Sources | Action |
|---|---|---|
| The cruise control is inoperative | Refer to the Diagnostic Routine | GO to Pinpoint Test A . |
| The cruise control indicator lamp is never/always on | Wiring, terminals and connectors PCM IPC |
REFER to Instrumentation, Message Center, and Warnin . |
| The cruise control switch is inoperative/does not operate correctly | Refer to the Diagnostic Routine | GO to Pinpoint Test C . |
| The cruise control cannot set above 105 kmh (65 mph), 113 kmh (70 mph), 121 kmh (75 mph), or 129 kmh (80 mph) | A MyKey® restricted key is in use and MyKey® maximum speed limiter is turned ON | VERIFY if a MyKey® restricted key is in use. VERIFY cruise control normal operation with an admin key. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.