Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2014F-150 FX2, 2D PICKUPREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 688 (STARTING SYSTEM)DIAGNOSIS AND TESTINGSTARTING SYSTEMSYMPTOM CHART
2014 Ford F-150 FX2, 2D Pickup
Symptom Chart
2014 Ford F-150 FX2, 2D PickupSECTION Symptom Chart
WARNING: This page is about a different car, the 2015 Lincoln MKS. However, it is still accessible from the selected car via links, so may be relevant.
Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. Refer to Diagnostic Methods in Service Information for information about these practices.
| Condition | Possible Sources | Action |
|---|---|---|
| The engine does not crank | Refer to the Diagnostic Routine | GO to Pinpoint Test A . |
| The engine cranks slowly | Battery Battery cables Starter motor Wiring, terminals or connectors |
CARRY OUT the Starter Motor - Feed Circuit and Starter Motor - Ground Circuit Tests. REFER to Component Tests . |
| The engine cranks but does not start. | Fuses Fuel pump Fuel pump relay PCM |
Engine Controls - Introduction (Except Diesel & Hybrid) |
| Unusual starter noise | Refer to the Diagnostic Routine | GO to Pinpoint Test B . |
| The starter spins but the engine does not crank | Starter motor | INSPECT the starter motor mounting and engagement. REFER to Starter Motor - 3.5L GTDI , or Starter Motor - 3.7L Ti-VCT , or Starter Motor Drive Gear and Flywheel Ring Gear Inspection . REPAIR as necessary. |
| Damaged flexplate | INSPECT the starter and flexplate for damaged, missing or worn teeth. REFER to Starter Motor Drive Gear and Flywheel Ring Gear Inspection . REPAIR as necessary. | |
| The starter does not disengage from the Flexplate | Starter relay Wiring, terminal or connectors |
REMOVE the starter relay, if the engine stops cranking INSTALL a new relay. If the engine continues to crank, REPAIR circuit CDC25 (BN/GN) for a short to voltage. |
| The remote start system operates with reduced range | Refer to the Diagnostic Routine | Diagnose the RKE Transmitter Has Poor Range performance. REFER to Handles, Locks, Latches and Entry Systems . |
| The remote start is inoperative | Refer to the Diagnostic Routine | GO to Pinpoint Test E . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.