Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2014F-150 FX2, 2D PICKUPREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 450 (BUMPER SYSTEM)SPECIFICATIONS
2014 Ford F-150 FX2, 2D Pickup
Section 450 (Bumper System): Specifications
2014 Ford F-150 FX2, 2D PickupSECTION Specifications
WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Front bumper bolts | 25 | 18 | - |
| Front bumper cover-to-air splitter screws | 1.7 | - | 15 |
| Front bumper cover-to-grille surround screws | 5.4 | - | 48 |
| Front bumper cover-to-inner fender screws | 1.7 | - | 15 |
| Front bumper cover reinforcement bolts | 2.2 | - | 19 |
| Front bumper cover upper bolts | 5.4 | - | 48 |
| Front lower valance-to-bumper cover bolts (5.0L) | 1.3 | - | 12 |
| Front lower valance-to-bumper cover bolts (GT500) | 1.3 | - | 12 |
| Lower air deflector bolts | 1.9 | - | 17 |
| Rear bumper bolts | 25 | 18 | - |
| Rear bumper cover reinforcement-to-body bolts | 25 | 18 | - |
| Rear mud flap screws | 3.2 | - | 28 |
| Underbody lower cover screws | 1.3 | - | 12 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.