DTC U0140 Lost Communication With Body Control Module: Description

2014 Ford F-150 FX2, 2D PickupSECTION Description
WARNING: This page is about a different car, the 2016 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

The PSCM monitors the HS-CAN messages when the ignition has been on for more than 5 seconds, the voltage to the PSCM is greater than 6.5 volts and there are no DTCs present inhibiting PSCM operation.

  • DTC U0140:00 (Lost Communication with the Body Control Module: No Sub Type Information) - This DTC sets when communication between the PSCM and the BCM fails. The BCM sends the following messages to the PSCM; alternator fault, ignition status, trailer lamp connectivity, and vehicle configuration. If these messages are missing for 5 seconds or more, DTC U0140:00 is set.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.