Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2014F-150 FX2, 2D PICKUPREPAIR AND DIAGNOSISBODY & FRAMESEAT SYSTEM - SEATSREMOVAL AND INSTALLATIONHEATED SEAT MODULE - REARINSTALLATION
2014 Ford F-150 FX2, 2D Pickup
Heated Seat Module - Rear: Installation
2014 Ford F-150 FX2, 2D PickupSECTION Installation
- Install the heated seat module and screw.
- Tighten to 14 Nm (124 lb-in).
- Connect the 2 electrical connectors.
- Raise and latch the backrest.
- Slide the striker pin up/down and align to the backrest latch.
- Make sure the backrest is fully latched.
- Carry out the auto-configuration sequence to program the heated seat module for use with a dual momentary switch.
- Start the vehicle and push the low button on either heated seat switch.
- Operate the heated seats, monitor the indicators and verify the system is operating correctly in high and low.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.