Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2014F-150 FX2, 2D PICKUPREPAIR AND DIAGNOSISBODY & FRAMESEAT SYSTEM - SEATSDISASSEMBLY AND ASSEMBLYSEAT CUSHION - REAR, CREWCABDISASSEMBLY
2014 Ford F-150 FX2, 2D Pickup
Seat Cushion - Rear, CrewCab: Disassembly
2014 Ford F-150 FX2, 2D PickupSECTION Disassembly
NOTE:
For parts identification and location, refer to SEAT - EXPLODED VIEW, REAR, CREW CAB .
- Remove the sea t cushion latch. Refer to SEAT LATCH - REAR, CREW CAB .
- Remove the cushion foam pad.
- If equipped, disconnect the cushion heater mat electrical connector.
- Note the wire harness routing for correct installation.
- If equipped, disconnect the cushion heater mat electrical connector.
- Remove the bolt and safety belt buckle.
- To install, tighten to 32 Nm (24 lb-ft).
- Remove the screw and inboard side shield.
- Remove the inboard pivot bolt, inboard pedestal and cushion.
- To install, tighten to 32 Nm (24 lb-ft).
- To assemble, reverse the disassembly procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.