Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Touchscreen Calibration
2014 Ford F-150 FX2, 2D PickupSECTION Touchscreen Calibration
NOTE:
Recalibrate the touchscreen by following the scan tool prompts or the steps below.
- To avoid an inoperative touchscreen, make sure the vehicle battery is fully charged.
- Turn on the ACM .
- While in AM/FM mode, press and hold the EJECT button, and within 1 second, press the SEEK UP button.
- Press and hold the SEEK DOWN button to enter the touchscreen calibration.
- Touch and hold the touch points as they appear on the touchscreen (a stylus is not required).
- To accept the new settings, touch anywhere on the screen when the screen displays "New calibration settings have been measured. Press the Enter key to accept the new settings."
- Clear all CMDTCs .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.