Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2014F-150 FX2, 2D PICKUPREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALWIRING DIAGRAMSOEM CONNECTOR END VIEWSTRANSFER CASE CONTROL MODULE (TCCM) CONNECTOR END VIEW (C2371B)
2014 Ford F-150 FX2, 2D Pickup
Transfer Case Control Module (TCCM) Connector End View (C2371B)
2014 Ford F-150 FX2, 2D PickupSECTION Transfer Case Control Module (TCCM) Connector End View (C2371B)
| Pin | Circuit | Gauge | Circuit Function | Qualifier |
|---|---|---|---|---|
| 1 | CCF03 (GY-BN) | 20 | CTRL MOD. - POWERTRAIN # FOUR WHEEL DRIVE CLUTCH (4WDC) | |
| 2 | * | * | Not Used | |
| 3 | GD123 (BK-GY) | 16 | GROUND - FENDER FRONT RIGHT | |
| 4 | CCF07 (BN-GN) | 16 | CTRL MOD. - POWERTRAIN # FOUR WHEEL DRIVE MOTOR CCW (4WDM) | |
| 5 | CCF08 (GY-OG) | 16 | CTRL MOD. - POWERTRAIN # FOUR WHEEL DRIVE MOTOR CW (4WDM) | |
| 6 | SBB20 (GN-RD) | 14 | FUSE - 20 OR CIRCUIT BREAKER | |
| 7 | SBB68 (GN-RD) | 14 | FUSE - 68 OR CIRCUIT BREAKER | |
| 8 | * | * | Not Used | |
| 9 | CCF31 (BN-VT) | 16 | CTRL MOD. - REAR DIFFERENTIAL LOCK | electronically locking differential |
| 10 | GD123 (BK-GY) | 16 | GROUND - FENDER FRONT RIGHT |
| Available Pigtail Kits | |
|---|---|
| Pigtail Kit Part Number WPT-1042 | Service Part Number: AU2Z-14S411-CA Gauge: 12 14 Pin material: Tin & Silver Cavities: 10 Vehicle Uses
|
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.