Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSFORD2014F-150 FX2, 2D PICKUPREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEWINDOWS AND GLASS - GLASS, FRAMES AND MECHANISMSREMOVAL AND INSTALLATIONWINDOW GLASS - REAR, MANUAL SLIDING PANEL

2014 Ford F-150 FX2, 2D Pickup

Window Glass - Rear, Manual Sliding Panel

2014 Ford F-150 FX2, 2D PickupSECTION Window Glass - Rear, Manual Sliding Panel

NOTE: For information on Ford Color Coded Illustrations refer to COLOR-CODING - FORD .

Remove the rear window glass assembly from the vehicle and place on a stable work surface. For additional information, refer to WINDOW GLASS - REAR .
Position the sliding glass panel to the full CLOSED position.
Remove the upper rail filler.
- Pull down the driver side of the upper filler while carefully sliding it out of the track towards the driver side of the rear glass assembly.
  
  Fig 1: Removing Upper Rail Filler
  Courtesy of FORD MOTOR CO.
Position the sliding glass panel to the full OPEN position.
Remove the lower rail filler.
- Pull up the passenger side of the lower filler while carefully sliding it out of the track towards the passenger side of the rear glass assembly.
  
  Fig 2: Removing Lower Rail Filler
  Courtesy of FORD MOTOR CO.
Push the sliding glass upward and tilt the bottom inward to disengage the sliding glass from the track. Remove the sliding glass panel.
To install, reverse the removal procedure.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.