SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2014ESCAPE SE, 2.0L ENG VIN 9, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS (EXCEPT DIESEL & HYBRID)DTC DIAGNOSISP0201 - CYLINDER 1 INJECTOR CIRCUIT/OPEN
2014 Ford Escape SE, 2.0L Eng VIN 9, AWD

P0201 - Cylinder 1 Injector Circuit/Open

2014 Ford Escape SE, 2.0L Eng VIN 9, AWDSECTION P0201 - Cylinder 1 Injector Circuit/Open
P0201 - CYLINDER 1 INJECTOR CIRCUIT/OPEN

Description:  The comprehensive component monitor (CCM) monitors the operation of the fuel injector drivers in the PCM. This DTC sets when the fuel injector circuitry is inoperative.
Possible Causes: 
  • VPWR circuit open (if equipped)
  • INJ1 circuit open
  • INJ1 circuit short to ground (direct injection vehicles)
  • INJ1 circuit short to voltage (direct injection vehicles)
  • INJ1RTN circuit open (if equipped)
  • INJ1RTN circuit short to ground (if equipped)
  • INJ1RTN circuit short to voltage (if equipped)
  • Damaged fuel injector 1
  • Damaged PCM
Diagnostic Aids:  For direct injection vehicles, the INJ1_F PID flags a concern. For all others, the INJ1_F PID flags equals YES.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
Edge 2.0L,
Escape 1.6L,
Escape 2.0L,
Explorer 2.0L,
Explorer 3.5L GTDI,
F-150 3.5L,
Fiesta 1.0L,
Fiesta 1.6L GTDI,
Flex 3.5L GTDI,
Focus,
Fusion 1.5L,
Fusion 1.6L,
Fusion 2.0L,
MKS 3.5L,
MKT 2.0L,
MKT 3.5L,
MKZ 2.0L,
Taurus 2.0L,
Taurus 3.5L GTDI,
Transit Connect 1.6L		 GO to PINPOINT TEST DI: DIRECT FUEL INJECTION FUEL INJECTOR .
All others GO to PINPOINT TEST KG: FUEL INJECTOR .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.