Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2014ESCAPE SE, 2.0L ENG VIN 9, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALWIRING DIAGRAMSOEM CONNECTOR END VIEWSFRONT CONTROL/DISPLAY INTERFACE MODULE (FCDIM) CONNECTOR END VIEW (C2123)
2014 Ford Escape SE, 2.0L Eng VIN 9, AWD
Front Control/Display Interface Module (FCDIM) Connector End View (C2123)
2014 Ford Escape SE, 2.0L Eng VIN 9, AWDSECTION Front Control/Display Interface Module (FCDIM) Connector End View (C2123)
| Pin | Circuit | Gauge | Circuit Function | Qualifier |
|---|---|---|---|---|
| 1 | SBP06 (BN-RD) | 20 | FUSE OR CIRCUIT BREAKER | |
| 2 | * | * | Not Used | |
| 3 | * | * | Not Used | |
| 4 | VDB13 (BU-GY) | 22 | CTRL MOD. - MULTIMEDIA CAN BUS HIGH | |
| 5 | VDB14 (VT-GY) | 22 | CTRL MOD. - MULTIMEDIA CAN BUS LOW | |
| 6 | * | * | Not Used | |
| 7 | VME14 (GY-YE) | 22 | SWITCH - REDUNDANT AUDIO + | |
| 8 | VMC29 (YE) | 22 | SWITCH - INFORMATION/MESSAGE CENTER SELECT | |
| 9 | GD138 (BK-WH) | 18 | GROUND - COWL SIDE/PILLAR A RIGHT (6L2T) | |
| 10 | RME24 (BU-WH) | 22 | CTRL MOD. - AUDIO # SWITCH REDUNDANT AUDIO | |
| 11 | GD138 (BK-WH) | 18 | GROUND - COWL SIDE/PILLAR A RIGHT (6L2T) | |
| 12 | * | * | Not Used |
| Available Pigtail Kits | |
|---|---|
| Pigtail Kit Part Number WPT-1278 | Service Part Number: CU2Z-14S411-ABA Gauge: 18 Pin material: Tin (greased) Cavities: 12 Vehicle Uses
|
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.