Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSFORD2014ESCAPE SE, 2.0L ENG VIN 9, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALBODY ELECTRICALOEM CONNECTOR END VIEWSREAR INTERIOR LAMP CONNECTOR END VIEW (C901)

2014 Ford Escape SE, 2.0L Eng VIN 9, AWD

Rear Interior Lamp Connector End View (C901)

2014 Ford Escape SE, 2.0L Eng VIN 9, AWDSECTION Rear Interior Lamp Connector End View (C901)

Fig 1: Identifying Rear Interior Lamp Connector (C901)

Courtesy of FORD MOTOR CO.

Pin	Circuit	Gauge	Circuit Function	Qualifier
1	CBP60 (YE-VT)	20	FUSE OR CIRCUIT BREAKER
2	*	*	Not Used
3	*	*	Not Used
4	VLN40 (YE-BU)	20	LAMP - DOME FRONT # DIM REAR
5	GD138 (BK-WH)	20	GROUND - COWL SIDE/PILLAR A LEFT	late production
6	VLN40 (YE-BU)	20	LAMP - DOME FRONT # DIM REAR	late production

Available Pigtail Kits
Pigtail Kit Part Number WPT-1249	Service Part Number: 3U2Z-14S411-BYAC Gauge: 18 Pin material: Silver Cavities: 6 Vehicle Uses Lamp - Dome Lamp - Storage Compartment - Cargo Motor - Heater A/C Mode Door Motor - Heater/AC Blend Door Motor - Heater/AC Inlet Door Switch - Hazard Warning Switch - Heated Seat Switch - Heater A/C Blower (Rear) Switch - Speed Control
Pigtail Kit Part Number WPT-956	Service Part Number: 3U2Z-14S411-BYAB Gauge: 18 Pin material: Silver Cavities: 6 Vehicle Uses Motor - Heater A/C Mode Door Motor - Heater/AC Blend Door Motor - Heater/AC Inlet Door Switch - Hazard Warning Switch - Heated Seat - LH - Front Switch - Heated Seat - LH - Rear Switch - Heated Seat - RH - Front Switch - Heated Seat - RH - Rear Switch - Heater A/C Blower (Rear)

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.