Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2014EDGE SE, 4D UTILITY, 3.5L ENG VIN C, FWDREPAIR AND DIAGNOSISQUICK LOOKUPSDTC INDEXWHEELS AND TIRES DTCSBODY CONTROL MODULE (BCM)
2014 Ford Edge SE, 4D Utility, 3.5L Eng VIN C, FWD
Body Control Module (BCM)
2014 Ford Edge SE, 4D Utility, 3.5L Eng VIN C, FWDSECTION Body Control Module (BCM)
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| B1182:00 | Tire Pressure Monitoring System (TPMS): No Sub Type Information | GO to PINPOINT TEST G . |
| B1182:55 | Tire Pressure Monitoring System (TPMS): Not Configured | This DTC is only present when a new BCM is installed, the BCM is flashed or the BCM reconfigured. TRAIN the tire pressure sensors. REFER to TIRE PRESSURE MONITORING SYSTEM (TPMS) SENSOR TRAINING . |
| B124D:02 | Tire Pressure Sensor: General Signal Failure |
NOTE:
If the vehicle has been stationary for more than 30 minutes, the sensors go into "sleep mode" to conserve battery power. It may be necessary to wake them up so they transmit the latest tire pressure information to the TPM
module. ACTIVATE the TPMS
sensors. REFER to TIRE PRESSURE MONITORING SYSTEM (TPMS) SENSOR TRAINING
.REPEAT the self-test. If DTC B124D:02 is retrieved again, GO to PINPOINT TEST G
. |
| B1251:00 | Tire Pressure Sensor Low Battery: No Sub Type Information | GO to PINPOINT TEST H . |
| B1254:51 | Right Rear (Outside on Dual Wheel) Tire Pressure Sensor and Transmitter Assembly: Not Programmed | This DTC is only present when a new BCM is installed, or the BCM is flashed or reconfigured. TRAIN the tire pressure sensors. REFER to TIRE PRESSURE MONITORING SYSTEM (TPMS) SENSOR TRAINING . |
| B1255:51 | Left Rear (Outside on Dual Wheel) Tire Pressure Sensor and Transmitter Assembly: Not Programmed | This DTC is only present when a new BCM
is installed, or the BCM
is flashed or the BCM
reconfigured. TRAIN the tire pressure sensors. REFER to TIRE PRESSURE MONITORING SYSTEM (TPMS) SENSOR TRAINING . |
| C1A56:51 | Left Front Tire Pressure Sensor and Transmitter Assembly: Not Programmed | This DTC is only present when a new BCM
is installed, or the BCM
is flashed or the BCM
reconfigured. TRAIN the tire pressure sensors. REFER to TIRE PRESSURE MONITORING SYSTEM (TPMS) SENSOR TRAINING . |
| C1A58:51 | Right Front Tire Pressure Sensor and Transmitter Assembly: Not Programmed | This DTC is only present when a new BCM
is installed, or the BCM
is flashed or the BCM
reconfigured. TRAIN the tire pressure sensors. REFER to TIRE PRESSURE MONITORING SYSTEM (TPMS) SENSOR TRAINING . |
| All other DTCs | - | refer to MULTIFUNCTION ELECTRONIC MODULES . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.