Steering Column Control Module

2014 Ford Edge SE, 4D Utility, 3.5L Eng VIN C, FWDSECTION Steering Column Control Module
STEERING COLUMN CONTROL MODULE DTC DESCRIPTION

DTC Description Action
B1298:09 Steering Column Adjust Up Switch: Component Failure INSTALL a new steering column control switch. REFER to STEERING COLUMN SWITCHES .
CLEAR the DTCs. VERIFY correct system operation. REPEAT the self-test.
If DTC B1298:09 returns, INSTALL a new Steering Column Control Module (SCCM). REFER to STEERING COLUMN SWITCHES .
CLEAR the DTCs. VERIFY correct system operation. REPEAT the self-test.
B1299:09 Steering Column Adjust Down Switch: Component Failure INSTALL a new steering column control switch. REFER to STEERING COLUMN SWITCHES .
CLEAR the DTCs. VERIFY correct system operation. REPEAT the self-test.
If DTC B1299:09 returns, INSTALL a new Steering Column Control Module (SCCM). REFER to STEERING COLUMN SWITCHES .
CLEAR the DTCs. VERIFY correct system operation. REPEAT the self-test.
B12A1:09 Steering Column Adjust Out Switch: Component Failure INSTALL a new steering column control switch. REFER to STEERING COLUMN SWITCHES .
CLEAR the DTCs. VERIFY correct system operation. REPEAT the self-test.
If DTC B12A1:09 returns, INSTALL a new Steering Column Control Module (SCCM). REFER to STEERING COLUMN SWITCHES .
CLEAR the DTCs. VERIFY correct system operation. REPEAT the self-test.
B12A2:09 Steering Column Adjust In Switch: Component Failure INSTALL a new steering column control switch. REFER to STEERING COLUMN SWITCHES .
CLEAR the DTCs. VERIFY correct system operation. REPEAT the self-test.
If DTC B12A2:09 returns, INSTALL a new Steering Column Control Module (SCCM). REFER to STEERING COLUMN SWITCHES .
CLEAR the DTCs. VERIFY correct system operation. REPEAT the self-test.
B1375:18 Steering Column Tilt Motor: Circuit Current Below Threshold GO to PINPOINT TEST A .
B1375:19 Steering Column Tilt Motor: Circuit Current Above Threshold GO to PINPOINT TEST A .
B1375:71 Steering Column Tilt Motor: Actuator Stuck GO to PINPOINT TEST A .
B137E:18 Steering Column Telescope Motor: Current Below Threshold GO to PINPOINT TEST A .
B137E:19 Steering Column Telescope Motor: Current Above Threshold GO to PINPOINT TEST A .
B137E:71 Steering Column Telescope Motor: Actuator Stuck GO to PINPOINT TEST A .
B1C33:11 Steering Column Tilt Feedback Signal: Circuit Short To Ground GO to PINPOINT TEST C .
B1C33:12 Steering Column Tilt Feedback Signal: Circuit Short To Battery GO to PINPOINT TEST C .
B1C35:11 Steering Column Telescope Feedback Signal: Circuit Short To Ground GO to PINPOINT TEST C .
B1C35:12 Steering Column Telescope Feedback Signal: Circuit Short To Battery GO to PINPOINT TEST C .
- All Other SCCM  DTCs REFER to STEERING COLUMN SWITCHES .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.