Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2014EDGE SE, 4D UTILITY, 3.5L ENG VIN C, FWDREPAIR AND DIAGNOSISQUICK LOOKUPSDTC INDEXINTERIOR LIGHTING SYSTEM DTCSHVAC MODULE
2014 Ford Edge SE, 4D Utility, 3.5L Eng VIN C, FWD
HVAC Module
2014 Ford Edge SE, 4D Utility, 3.5L Eng VIN C, FWDSECTION HVAC Module
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| B127C:11 | Ambient Lighting Zone 2 Output Red LED: Circuit Short To Ground | GO to PINPOINT TEST K . |
| B127C:13 | Ambient Lighting Zone 2 Output Red LED: Circuit Open | GO to PINPOINT TEST K . |
| B127F:11 | Ambient Lighting Zone 2 Output Green LED: Circuit Short To Ground | GO to PINPOINT TEST K . |
| B127F:13 | Ambient Lighting Zone 2 Output Green LED: Circuit Open | GO to PINPOINT TEST K . |
| B1282:11 | Ambient Lighting Zone 2 Output Blue LED: Circuit Short To Ground | GO to PINPOINT TEST K . |
| B1282:12 | Ambient Lighting Zone 2 Output Blue LED: Circuit Short To Battery | GO to PINPOINT TEST K . |
| B12F2:11 | Ambient Lighting Zone 2 Output: Circuit Short To Ground | GO to PINPOINT TEST K . |
| B12F2:13 | Ambient Lighting Zone 2 Output: Circuit Open | GO to PINPOINT TEST K . |
| All other DTCs | - | REFER to the HVAC - CLIMATE CONTROL SYSTEM - GENERAL INFORMATION AND DIAGNOSTICS . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.