Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2014EDGE SE, 4D UTILITY, 2.0L ENG VIN 9REPAIR AND DIAGNOSISQUICK LOOKUPSDTC INDEXSTEERING COLUMN DTCSSTEERING COLUMN CONTROL MODULE
2014 Ford Edge SE, 4D Utility, 2.0L Eng VIN 9
Steering Column Control Module
2014 Ford Edge SE, 4D Utility, 2.0L Eng VIN 9SECTION Steering Column Control Module
STEERING COLUMN CONTROL MODULE DTC DESCRIPTION
| DTC | Description | Action |
|---|---|---|
| B1298:09 | Steering Column Adjust Up Switch: Component Failure | INSTALL a new steering column control switch. REFER to
STEERING COLUMN SWITCHES
. CLEAR the DTCs. VERIFY correct system operation. REPEAT the self-test. If DTC B1298:09 returns, INSTALL a new Steering Column Control Module (SCCM). REFER to STEERING COLUMN SWITCHES . CLEAR the DTCs. VERIFY correct system operation. REPEAT the self-test. |
| B1299:09 | Steering Column Adjust Down Switch: Component Failure | INSTALL a new steering column control switch. REFER to
STEERING COLUMN SWITCHES
. CLEAR the DTCs. VERIFY correct system operation. REPEAT the self-test. If DTC B1299:09 returns, INSTALL a new Steering Column Control Module (SCCM). REFER to STEERING COLUMN SWITCHES . CLEAR the DTCs. VERIFY correct system operation. REPEAT the self-test. |
| B12A1:09 | Steering Column Adjust Out Switch: Component Failure | INSTALL a new steering column control switch. REFER to
STEERING COLUMN SWITCHES
. CLEAR the DTCs. VERIFY correct system operation. REPEAT the self-test. If DTC B12A1:09 returns, INSTALL a new Steering Column Control Module (SCCM). REFER to STEERING COLUMN SWITCHES . CLEAR the DTCs. VERIFY correct system operation. REPEAT the self-test. |
| B12A2:09 | Steering Column Adjust In Switch: Component Failure | INSTALL a new steering column control switch. REFER to
STEERING COLUMN SWITCHES
. CLEAR the DTCs. VERIFY correct system operation. REPEAT the self-test. If DTC B12A2:09 returns, INSTALL a new Steering Column Control Module (SCCM). REFER to STEERING COLUMN SWITCHES . CLEAR the DTCs. VERIFY correct system operation. REPEAT the self-test. |
| B1375:18 | Steering Column Tilt Motor: Circuit Current Below Threshold | GO to PINPOINT TEST A . |
| B1375:19 | Steering Column Tilt Motor: Circuit Current Above Threshold | GO to PINPOINT TEST A . |
| B1375:71 | Steering Column Tilt Motor: Actuator Stuck | GO to PINPOINT TEST A . |
| B137E:18 | Steering Column Telescope Motor: Current Below Threshold | GO to PINPOINT TEST A . |
| B137E:19 | Steering Column Telescope Motor: Current Above Threshold | GO to PINPOINT TEST A . |
| B137E:71 | Steering Column Telescope Motor: Actuator Stuck | GO to PINPOINT TEST A . |
| B1C33:11 | Steering Column Tilt Feedback Signal: Circuit Short To Ground | GO to PINPOINT TEST C . |
| B1C33:12 | Steering Column Tilt Feedback Signal: Circuit Short To Battery | GO to PINPOINT TEST C . |
| B1C35:11 | Steering Column Telescope Feedback Signal: Circuit Short To Ground | GO to PINPOINT TEST C . |
| B1C35:12 | Steering Column Telescope Feedback Signal: Circuit Short To Battery | GO to PINPOINT TEST C . |
| - | All Other SCCM DTCs | REFER to STEERING COLUMN SWITCHES . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.