Driver Seat Module (DSM)

2014 Ford Edge SE, 4D Utility, 2.0L Eng VIN 9SECTION Driver Seat Module (DSM)
DTC INDEX

DTC Description Action
B106E Solid State Driver Disabled Due to Short Circuit GO to PINPOINT TEST F .
B106F Module Disabled Due to External Fault GO to PINPOINT TEST F .
B1667 Mirror Driver Up/Down Motor Stalled GO to PINPOINT TEST D .
B1668 Mirror Driver Right/Left Motor Stalled GO to PINPOINT TEST D .
B1669 Mirror Passenger Up/Down Motor Stalled GO to PINPOINT TEST D .
B1670 Mirror Passenger Right/Left Motor Stalled GO to PINPOINT TEST D .
B1733 Mirror Driver Vertical Switch Circuit Failure GO to PINPOINT TEST D .
B1737 Mirror Driver Horizontal Switch Circuit Failure GO to PINPOINT TEST D .
B1741 Mirror Passenger Vertical Switch Circuit Failure GO to PINPOINT TEST D .
B1745 Mirror Passenger Horizontal Switch Circuit Failure GO to PINPOINT TEST D .
B2223 Mirror Driver Drive Circuit Failure GO to PINPOINT TEST D .
B2224 Mirror Passenger Drive Circuit Failure GO to PINPOINT TEST D .
B2312 Mirror Passenger Horizontal Feedback Potentiometer Circuit Failure GO to PINPOINT TEST D .
B2314 Mirror Passenger Horizontal Feedback Potentiometer Circuit Short to Battery GO to PINPOINT TEST D .
B2316 Mirror Passenger Vertical Feedback Potentiometer Circuit Failure GO to PINPOINT TEST D .
B2318 Mirror Passenger Vertical Feedback Potentiometer Circuit Short to Battery GO to PINPOINT TEST D .
B2320 Mirror Driver Horizontal Feedback Potentiometer Circuit Failure GO to PINPOINT TEST D .
B2322 Mirror Driver Horizontal Feedback Potentiometer Circuit Short to Battery GO to PINPOINT TEST D .
B2324 Mirror Driver Vertical Feedback Potentiometer Circuit Failure GO to PINPOINT TEST D .
B2326 Mirror Driver Vertical Feedback Potentiometer Circuit Short to Battery GO to PINPOINT TEST D .
All other DTCs - REFER to SEATING .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.