SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2014EDGE SE, 4D UTILITY, 2.0L ENG VIN 9REPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS (EXCEPT DIESEL & HYBRID)DTC DIAGNOSISP0202 - CYLINDER 2 INJECTOR CIRCUIT/OPEN
2014 Ford Edge SE, 4D Utility, 2.0L Eng VIN 9

P0202 - Cylinder 2 Injector Circuit/Open

2014 Ford Edge SE, 4D Utility, 2.0L Eng VIN 9SECTION P0202 - Cylinder 2 Injector Circuit/Open
P0202 - CYLINDER 2 INJECTOR CIRCUIT/OPEN

Description:  The comprehensive component monitor (CCM) monitors the operation of the fuel injector drivers in the PCM. This DTC sets when the fuel injector circuitry is inoperative.
Possible Causes: 
  • VPWR circuit open (if equipped)
  • INJ2 circuit open
  • INJ2 circuit short to ground (direct injection vehicles)
  • INJ2 circuit short to voltage (direct injection vehicles)
  • INJ2RTN circuit open (if equipped)
  • INJ2RTN circuit short to ground (if equipped)
  • INJ2RTN circuit short to voltage (if equipped)
  • Damaged fuel injector 2
  • Damaged PCM
Diagnostic Aids:  For direct injection vehicles, the INJ2_F PID flags a concern. For all others, the INJ2_F PID flags equals YES.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
Edge 2.0L,
Escape 1.6L,
Escape 2.0L,
Explorer 2.0L,
Explorer 3.5L GTDI,
F-150 3.5L,
Fiesta 1.0L,
Fiesta 1.6L GTDI,
Flex 3.5L GTDI,
Focus,
Fusion 1.5L,
Fusion 1.6L,
Fusion 2.0L,
MKS 3.5L,
MKT 2.0L,
MKT 3.5L,
MKZ 2.0L,
Taurus 2.0L,
Taurus 3.5L GTDI,
Transit Connect 1.6L		 GO to PINPOINT TEST DI: DIRECT FUEL INJECTION FUEL INJECTOR .
All others GO to PINPOINT TEST KG: FUEL INJECTOR .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.